plug in your cm device to get started wraith prism

my computer uses corsair ML RGB fans and an AX1600i PSU, 4 USB port PCI bracket, USB 2 ports at the front, memory card reader, etc.

at least not in a way that is reasonably priced or cross compatible with other brands (i'm looking at you corsair commander). Overall Review: lots of accessory brands LOVE making trinkets that take up USB headers on the motherboard but never provide a way to connect it all. but i am willing to overlook these shortcomings It has been 3 days and I have not had any problems.Ĭons: -i wish it was a little bit more compact and used SATA power input instead of molex. I was very careful and diligent when mating the power connector and was rewarded with extra USB ports. I knew this after reading the reviews and decided to give it a chance anyway. The connector pins are very loose and seem to float and move freely within the housing, so you must be very careful when mating this connector with your system. I would not consider it a real connector at all. Others have described the provided molex power connector as insufficient. I have a Rosewill Blackhawk Ultra case, so room was not an issue. I wanted to utilize my cases' front panel USB connectors and this filled the bill. My new motherboard only had a single USB 2.0 header, which I used for the Corsair Link cable of my AOI cooling system. Overall Review: I found this to be exactly what I needed. Did you also make the connection to the CPU_FAN header? That is where the cooler gets its power for both the fan and the lights, AND where its fan speed is controlled, AND how the mobo can check that the fan actually is working (from the speed signal).* Velcro cable management straps provided I hope you did NOT also connect the other cable for Option (a).

Then you DO need to download and use the lighting control software utility. The other end of that plugs into a mobo (10-1) pin USB2 header. You use the other cable with THREE holes in one end, and plug it into the OTHER (3-pin) socket on the cooler side. (b) INSTEAD of that, if you choose, or if you have no 4-pin plain RGB mobo header (this appears to be your case, OP) you do not use that cable. If you use this method you do not need the special software for the Wraith Prism. If you have such a header, this way you can synchronize the Prism's display with your other plain RGB lights. (a) connect a cable with FOUR holes into a recessed 4-pin socket on the side of the cooler, and the other end of this goes to a mobo 4-pin (12 VDC) PLAIN RGB header IF you have one. There are two connections to make with the Wraith Prism, and one NOT to make.įirst, its female 4-pin FAN connector must plug into your mobo's CPU_FAN header.

Plug in your cm device to get started wraith prism